I've been patiently waiting for Gerhauer to send my new traveller . IMG_5588.png
Now , if only it would stop snowing , raining long enough ..
My 4:1 mainsheet/mast raising setup is from them, very nice kit, I am sure you will like yours.
The bearings in the original traveller were more than 40 years old .I machined new shafts for replacement bearings.
The new bearings were fractionally wider than the old ..
After a very nice exchange of emails , the fine folks at Gerhauer easily convinced me it was time for an upgrade .
Harken is only a few miles from here . I had thought I would go that route . Gerhauer was willing to bore the through holes to match my existing hole pattern for no extra cost .That sold me .