Finally !

[Timm R Oday25]

I've been patiently waiting for Gerhauer to send my new traveller . You cannot view this attachment.
Now , if only it would stop snowing , raining long enough ..

[Spot]

My 4:1 mainsheet/mast raising setup is from them, very nice kit, I am sure you will like yours.

[Timm R Oday25]

The bearings in the original traveller were more than 40 years old .I machined new shafts for replacement bearings.
The new bearings were fractionally wider than the old ..
After a very nice exchange of emails , the fine folks at Gerhauer easily convinced me it was time for an upgrade .
Harken is only a few miles from here . I had thought I would go that route . Gerhauer was willing to bore the through holes to match my existing hole pattern for no extra cost .That sold me .